![]() ![]() ![]() The will align bot lights, the high and low sine both are connected to the same headlight!!įord Requires a special tool to adjust headlights, you can buy from ford or Mac or snap-on tools. This will assure that the lights are tilted slightly downward so they won’t blind approaching motorist. Then adjust the vertical alignment of both beams slightly below the marks on the wall. Turning the side adjuster screws will adjust the lights to the left or right.Ĭontinue the adjustments until the center of the light beams are aligned with the tape marks. Turning the top adjusting screws in a clockwise direction will raise the beam while counterclockwise turn will lower it. Make the necessary adjustments with the lights still on while watching the light beams on the wall and your marks. If the centerlines of the two beams do not align with the tape marks, you can adjust one or both sides as needed. ![]() Use the markings you made on the wall or garage door to, check where the light shines and see if the centerlines still match up with the masking tape marks. Keep the headlights on the low beam setting. Move the vehicle back about 10 to 25 feet away from the garage door or the wall. The marking will tell you where exactly the headlight beams should be centered from a distance. This will mark the center of each beam with a +. Switch on the low headlight beams and mark the horizontal and vertical centerlines of each headlight beams on the wall using masking tape. The location must be perfectly level and flat at a distance of 10 to 25 feet away from the door or wall. A good distance is 2-3 feet away from the wall or door. Park your vehicle on level ground with the headlights near a garage door or wall. If it says VOL or nothing, aim them 2 inches below the mark on the wall.įor High Beams (if separate from low beams): Aim the headlight directly at the line you marked on the wall. Your car on a level ground 30 feet from a wall and measure the heightįrom the ground to the bulb and mark on a wall (do this for highs beamsĪnd low beams if the bulbs are separate, if highs and lows are the sameįor Low Beams: If the headlights read VOR, thenĪim the brightest part or cutoff part just below the mark on the wall. (separate highs and separate lows, but will be same screw if highs and You will have vertical adjustment screws for each independent beam The adjustment screws/nuts should be located either on the top of the headlamp assembly,īehind the headlamp assembly, or near the frame rail by the radiator SOURCE: how do I align low beam headlight in 2006 honda ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |